Lead-acid VRLA Battery

Lead-acid VRLA Battery

Valve Regulated Lead Acid (VRLA) batteries are by far the most common choice for modern UPS systems based on their low maintenance, reliability, cost-effectiveness and well-established recycling infrastructure.

Built up of a series of blocks each containing cells of lead and lead oxide plates immersed in sulphuric acid electrolyte, VRLA battery systems can be easily tailored to specific room layouts and autonomies. They are available as internal batteries (depending on UPS / EL model), in ventilated battery cabinets or in open or cladded racks.

Modern systems can be configured with battery monitoring, which reports on the health of each block, or active battery management, which adds charge balancing so that each block is charged according to its needs, typically extending life by around 30%.

More Information

Sourced from a variety of high-quality manufacturers such as GS YUASA, modern VRLA batteries are environmentally friendly and safer than earlier open-vented types. This is because today’s VRLA batteries are around 98% recyclable, with well developed recycling infrastructure in most developed countries such as the reputable, trusted partners KOHLER Uninterruptible Power works with.

Unlike earlier open vented cells that needed regular topping up, today’s batteries are sealed units that require no user maintenance, though for maximum resilience inspection and periodic testing by qualified service engineers is recommended. A valve allows venting of gases generated in emergency/over-pressure situations, though the amount given off is so small that it can normally be handled by standard air handling equipment used to control temperature. On this point, it is important to note that as a device based on temperature-dependent chemical reactions, VRLA batteries require a temperature-controlled environment. The best balance between operating performance and lifetime is achieved at 20 deg C. As a rule of thumb, for every 10 deg C above this the working life will halve. The useful working life of the battery is also affected by how the battery is used, so great care must be taken when selecting and sizing batteries for a UPS installation.

VRLA batteries can be housed in cabinets alongside the UPSs rather than in separate battery rooms, even if the UPSs are operating within an office environment. However, because the combined voltage of the battery system will be the same as a mains electricity supply, for safety reasons it should be protected from unauthorised or accidental contact.

All batteries should be regularly checked or a fixed battery monitoring system should be used. Eventually, they will require replacement, however, this life can be maximised by taking care to operate within a well-managed environment and setting up a regular maintenance schedule. An active battery management system that balances charging between battery “blocks” will potentially increase lifetime by up to 30%.

A VRLA battery block is a number of cells connected together with a given voltage and capacity, where. the capacity is defined in terms of Ampere hours (Ah). The more cells the higher the battery voltage and the larger the plates the higher the battery capacity.

Batteries are generally made in 12-volt blocks using six cells but are also available in 6-volt (three cell), 4-volt (two cell) and 2-volt (single cell) blocks. In the battery configuration, all the cells used in a serial string must be identical to each other. KUP’s expert team have a wealth of experience and a variety of specialised planning tools to help them offer you a solution that perfectly meets your voltage, autonomy and space requirements.

Disposal/Recycling

When a battery has reached the end of its useful working life it must be returned to the point of sale or to a licensed battery dealer for recycling. ‘Old’ batteries are classified as ‘hazardous waste’ and must be disposed of in line with current legislation. KOHLER Uninterruptible Power can assist with the disposing/recycling of VRLA batteries. There is a well-established infrastructure to recycle approximately 98% of the content of end-of-life VRLA batteries into new batteries, plastic items and chemicals used in the glass and textiles industries (see diagram).

What is a battery?

A battery is a device that uses chemical means to store electrical energy and can be found in any number of shapes, sizes, voltages and capacities.

When two materials (usually dissimilar metals) are immersed in a solution (electrolyte) they conduct electricity between the ‘plates’ which gives rise to an electrical potential. The value of the potential (or voltage) depends on the plate materials and the electrolyte used. Examples of different battery composition include lead-acid, nickel cadmium (Ni-Cad), and lithium-ion.

Product Enquiry

From initial contact through installation, service, maintenance to disposal, KUP provides its customers with an unrivalled single source for complete power protection.

Alternatively fill out the enquiry form and our sales team will get in touch with you:

Enquiry Form












    We would like to keep in touch with you from time to time! If you would like to hear from us, please let us know what you are interested in:

    To learn more about these options and what they mean, please view our Marketing Communications page.

    On hand and ready to support you

    Whether considering design concepts for a new facility or how to tackle an upgrade, our trusted experts are on hand to help you find an efficient, resilient system and service package that works for you.

    Or why not give us a call on 0800 731 3269 and chat directly to a member of our team.

    Professional helpline call center agent